Outboard Trim/Tilt Pin Wrench MT0004-38mm x 4mm For Seastar, 4 Stroke Yamaha V6

Description

Application:
Fits all Seastar Steering Cylinders, Trim and Tilt Caps on all Four Stroke Yamaha V6, Trim and Tilt Caps on Non-VMAX 2 Strokes (225-300hp), and Tilt Caps on the 2011-Current F150. This wrench is not compatible with VMAX.
Function:
To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder.
A Must Have:
Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease.
High Quality Material:
Made of high hardened 4140 impact grade steel,with silver oxide coating which is rust-resistance and durable to use.Better than OEM.
Outboard Trim/Tilt Pin Wrench MT0004-38mm x 4mm
Fitment:
All SeaStar Steering Cylinders
Trim and Tilt caps on ALL Four Stroke V6 (F200-F300)(3.3L, 4.2L)
Trim and Tilt Caps 2 strokes (225-300hp)(Non VMAX)
Tilt Cap ONLY on 2011-Current F150
Does NOT fit VMAX
Function:
Rebuild the trim seal on the trim and tilt unit. Used to remove and install the trim caps without damage
Strength:
Trim and Tilt hydraulic pin wrench. 180 ft-lb MIN Pin Strength.
Replacement:
Equivalent Yamaha Factory Toosl YB-06175-2B, Replacement Pins AMT0005 - S-4mm